Transportable Nanoleaf Mount

I had to take down my Nanoleaf due to some remodeling we were doing, and at the same time a lot of people at work wanted to see what it looked like in person, so out of a desire to never have to worry about setting it up again, I used some thin 1/4″ plywood to make an easily transportable mount and hung it using some simple wall clips that only leave a tiny hole in the wall. I’m leaving it on the wall at work until wifey and I “agree” on where to put it now that the old wall it was on is no longer accessible (might be a while…)

Leave a Reply

Your email address will not be published. Required fields are marked *